I can't do any testing right now because my printer is down and requires some expensive replacement parts. the PSU is shorting. the touchscreen is fried and I have no clue if the motion controller is working or not as I have no way to power it.
The touchscreen replacement is the most expensive part. I've found a source for the PSU, which I may also be able to send the one I have in to be repaired. radwell has a repair facility and has repair this unit. the ultimate issue is how much repair costs.
the PSU has been weird. I have had it run where it will not short out anything. I go to put all the parts in place and it shorts. (blowing out the GFI reset on the wall socket).
I haven't heard from jetguy yet either.
I've just a little bit concerned with just posting the firmware out, which is why I didn't put it on github. XYZ movements responded correctly to the touchscreen when I tested it. on the RC8 I was able to print but I don't know how much different this one is.
I need some additional people to test it. you will need to configure the firmware for your printer. I have designed it to be easily configured like the current firmware is.
we need to test both single and dual extrution settings.
need someone with a BLtouch to test the BLtouch.
RL name: Michael Nolen