First Print

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
Posts: 1
Joined: Sun Apr 09, 2017 9:49 pm

First Print

Postby htalukder » Sun Apr 09, 2017 10:00 pm

Hello Raisers,
Got my N2 plus on Friday, getting good quality print without big surprise till now.
My question regarding the part I attached the image. It was not mentioned at all in the Quick Start and I did not mount it.
Have a pretty good idea where it will go. But printing without any issues without the part.
Should I still go ahead and mount it? Or this is required for any specific filament?
Thanks in advance.

User avatar
Posts: 3618
Joined: Fri Mar 25, 2016 3:54 am

Re: First Print

Postby Vicky@Raise3D » Mon Apr 10, 2017 8:15 am

It is not a necessary part unless your filament tends to break during print head's fast movement.

Here is the installation guide.

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 4 guests