Page 1 of 1

Raise3D-printers compatible with Astroprint?

Posted: Mon Feb 27, 2017 8:01 am
by Noren
Hi.
I wonder if the Astroprint box www.astroprint.com is compatible with the Raise3D-printers.
Since there are now way to connect to the printer via internet to show the status screen. The Astroprint box seems like a god alternative to use to monitor the printer, temperatures, progress and so on.
Anyone that uses it?

On there site they say:
AstroPrint is compatible with standard Marlin & Sailfish firmware based printers. If your printer runs on proprietary firmware or heavily modified Marlin/Sailfish firmware, it's unlikely that it would work with AstroPrint.

I really don't care for the slicing features but mainly about the remote monitoring features.
/Andreas

Re: Raise3D-printers compatible with Astroprint?

Posted: Mon Feb 27, 2017 5:08 pm
by walshlg
good luck, let us know if you make any progress. I have asked repeatedly for the Printer API but never got a single response

Re: Raise3D-printers compatible with Astroprint?

Posted: Tue Feb 28, 2017 7:42 am
by Vicky@Raise3D
May cannot use. Cause we are not using standard Marlin, but a modified firmware.

Re: Raise3D-printers compatible with Astroprint?

Posted: Wed Mar 01, 2017 3:41 pm
by Ikoth
Another upvote for external monitoring for the N2+ please, either via API (ideally), or a web interface that can be "scraped" to collect data.

Re: Raise3D-printers compatible with Astroprint?

Posted: Thu Mar 02, 2017 3:11 am
by Vicky@Raise3D
Well noted. Will pass to software department.

Re: Raise3D-printers compatible with Astroprint?

Posted: Fri Jan 12, 2018 5:58 pm
by woodwind
the astrobox should work ith raise 2d plus or not? Is there anyone who uses this?

Re: Raise3D-printers compatible with Astroprint?

Posted: Sat Jan 13, 2018 10:53 pm
by sylus
Yes it works,as octoprint too but with the sacrifice of the raisetouch.