N2 Stopping Mid Print, Serial Error After Restart

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
Hathaway
Posts: 2
Joined: Wed Oct 17, 2018 6:11 pm

N2 Stopping Mid Print, Serial Error After Restart

Postby Hathaway » Wed Oct 17, 2018 6:40 pm

Strangest thing, my N2 printer was working fine until about a week ago when suddenly my printer just began stopping at random points during prints. The hotends and heatbed remain hot while it just sits there, not moving, not extruding. I manually power-cycle and afterwards the screen reads "We encountered a serial error during last build!" and also provides options to recover, restart, or cancel the current task. I used to select recover until today when the printer wont even go 15 minutes without getting hung up again.... Please help!

User avatar
Vicky@Raise3D
Posts: 4427
Joined: Fri Mar 25, 2016 3:54 am

Re: N2 Stopping Mid Print, Serial Error After Restart

Postby Vicky@Raise3D » Wed Oct 17, 2018 10:01 pm

Whether your screen was controllable by touching at that moment?

Hathaway
Posts: 2
Joined: Wed Oct 17, 2018 6:11 pm

Re: N2 Stopping Mid Print, Serial Error After Restart

Postby Hathaway » Wed Oct 17, 2018 10:09 pm

No, the screen isn't controllable before manually restarting.

User avatar
Vicky@Raise3D
Posts: 4427
Joined: Fri Mar 25, 2016 3:54 am

Re: N2 Stopping Mid Print, Serial Error After Restart

Postby Vicky@Raise3D » Thu Oct 18, 2018 11:31 pm

Might be some issue related to touchscreen. Would you like to open a support ticket to contact our technicians at http://help.raise3d.com?


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 8 guests