Bltouch on N2+

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
Anthonyvanv
Posts: 12
Joined: Wed Mar 28, 2018 1:03 pm

Bltouch on N2+

Postby Anthonyvanv » Tue Sep 25, 2018 2:17 pm

I'm having a hard time configuring the Bltouch. I can't seem to find any good tutorials online for this. I've got the bltouch mounted properly and its wired. The blue light comes on the sensor. The problem is when I go to run any type of GCode, it gets to the autolevel part and the sensor doesn't deploy and the bed moves DOWN, not up to touch the sensor. Can anyone help me please?


I've uploaded the firmware that was on the thingiverse mount.

Alex M.
Posts: 194
Joined: Tue Apr 10, 2018 4:59 pm

Re: Bltouch on N2+

Postby Alex M. » Tue Sep 25, 2018 5:07 pm

Have you checked this thread? viewtopic.php?f=4&t=1030

Anthonyvanv
Posts: 12
Joined: Wed Mar 28, 2018 1:03 pm

Re: Bltouch on N2+

Postby Anthonyvanv » Tue Sep 25, 2018 7:28 pm

Yes but I don't think the firmware works. like I said, I've hooked it up and everything but it doesn't do what its supposed to do.

Alex M.
Posts: 194
Joined: Tue Apr 10, 2018 4:59 pm

Re: Bltouch on N2+

Postby Alex M. » Tue Sep 25, 2018 11:19 pm

Which firmware are you using? The file in thingiverse from Sylus, here. Or the version in github by ABH, here?

I would personally use ABH's firmware however you will need to compile it. These two posts might help too, #1 & #2.
By the way I don't have a Bltouch and am only going by what I have read here.

sylus
Posts: 108
Joined: Fri Aug 05, 2016 9:47 pm

Re: Bltouch on N2+

Postby sylus » Wed Sep 26, 2018 10:57 am

my reco is to use ABH firmware because it uses the last marlin revision 1.1.9


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 9 guests