Bed Adhesion/Proper Raft Squish

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
Snalios
Posts: 17
Joined: Thu Aug 09, 2018 1:39 pm

Bed Adhesion/Proper Raft Squish

Postby Snalios » Tue Aug 28, 2018 3:59 pm

I'm having issues getting the proper squish of my raft, and thus I'm getting warping.

I'm printing with a 0.6mm nozzle, and am using a 0.15mm feeler gauge. I understand that using that nozzle gap with a 0.6 nozzle will cause an pressure buildup in my hotend; however, it's the only way I can get somewhat good squish on my raft. I'm printing with the standard Ideamaker starting g-code. And my first layer raft speed is set to 3.0mm/s.

Any tips or recommendations to settings to get the squish better?

Return to “Hardware”

Who is online

Users browsing this forum: Mickej65 and 13 guests