Set Bltouch on Raise3D N2 Dual strictly according to instructions. The sensor works, the printer prints. But sensor works weird. Every time you have to put a new Z-offset. Same file the printer prints different from the first layer. In different corners of the table as the first layer is also different. Little bit helps restart the printer, the first measurement of the table is the most accurate. Starting to regret installing this sensor.
Please tell me what I did wrong and how to fix it.
Did you activate eeprom?to set offset I recommande you to attach an reprap discount LCD to manage it until Raise3D implement it in Raisetouch.