N2 power failure

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
hhilmarsson
Posts: 4
Joined: Mon Sep 05, 2016 2:14 pm

N2 power failure

Postby hhilmarsson » Wed Sep 13, 2017 12:23 am

I've been running my N2 for almost a year now and suddenly it just died. I tried couple of times to turn it on again and it started but died again. What I figured out was that it was probably bad connection. I turned it on the side and looked at the power inlet and the power supply. The problem was bad or loose connectors at the power inlet. I had to use pliers to squeeze the connectors together to make solid contact. Please be aware of that and make sure you have quality connectors.
20170911_170416.jpg

/H
/hhilmarsson

User avatar
Brandon
Posts: 100
Joined: Fri May 05, 2017 1:22 pm

Re: N2 power failure

Postby Brandon » Wed Sep 13, 2017 2:24 pm

Noted. I will pass this along. Anyone viewing this thread please note. Unplug the power before attempting to put any tool on the terminals of the power inlet of the printer !!!


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 3 guests