When printing with dense support layers I sometimes get that the first layer above the dense support layer doesn't adhere to the next layer.
The only option we have to set the distance between the dense support layer and the print is in the increment of 1 layer or more.
Wouldn't it make sense to have this option in mm's instead?
If I print at 0.2 mm layer height I know get a distance from dense support layer to print at 0.2 layer.
I would like to set this at 0.1 mm. To minimise the sagging of the layer above the dense support.
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Notes taken. We will consider to use mm as unit for support distance instead of layer in future versions.
Who is online
Users browsing this forum: No registered users and 3 guests