Has anyone tried changing the value for the raft gap from model setting? No matter what value I set it to, the gcode seems to come out the same. For example, I have a raft test cube where I have set the gap to be 1 mm (way higher than it should be), but the first layer of cube above the raft is only 0.1 mm above the top layer of the raft, not the 1 mm it should be.
What other settings should I try changing if I'm finding my parts to be too difficult to remove from the raft?
Discussions about ideaMaker and other printing software.
4 posts • Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 3 guests