Ideamaker bridging and brim/skirt adjustments?

Discussions about ideaMaker and other printing software.
GlowingEmbers
Posts: 1
Joined: Sun Jun 17, 2018 11:23 pm

Ideamaker bridging and brim/skirt adjustments?

Postby GlowingEmbers » Sun Jun 17, 2018 11:35 pm

Hi

I have two questions on the Ideamaker software:

Does bridging usually include shells?
Also, is there a way to customize the gap on brims? I'm trying to adjust the brim gap so it can provide adhesion without being too stuck to the print. There is no config for brims and it seems skirts have a 1mm minimum,

User avatar
Vicky@Raise3D
Posts: 3768
Joined: Fri Mar 25, 2016 3:54 am

Re: Ideamaker bridging and brim/skirt adjustments?

Postby Vicky@Raise3D » Tue Jun 19, 2018 2:09 am

1. Bridge bridging settings are applied to solid fill sections only.
2. If you want to have gap between extra bed adhesive structure and model, you'd better use Skirt.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 4 guests