When i make an Object that has a 2mm wall and then in the Slicer Idea maker i select more the 2 shells the 2mm walls become hollow and have no top layers or bottom layers plus only shows 2 shells. then i return the slicer settings to 2 shells and slice it again it does the infill and top and bottom layers..
all stock settings materials does the same.
Goal is making a PolyFlex Belt for a project. the shells are the infill, as it has more strength in the belt then using an 100% infill with less shells.
3mm and more no issues just 2mm walls.
Anyone else can replicate this issue?
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests