Bridging is askew and ends in mid air.

Discussions about ideaMaker and other printing software.
User avatar
Noren
Posts: 401
Joined: Sat Nov 26, 2016 12:54 am
Location: Borås, Sweden
Contact:

Bridging is askew and ends in mid air.

Postby Noren » Fri Jan 19, 2018 12:03 pm

HI. Look att the attached file.
I have noticed this behaviour for a while.
On the first bridging layer. The bridging is not aligned with the shell. It is a few degrees off.
And on some places that causes a gap in the bridging.
And it also causes the bridging to start and stop mid air in some places.

/Andreas
Attachments
CHAINMEAIL TEST 1 PLA-export.bin.zip
(6.92 KiB) Downloaded 11 times
chainmail gcode.zip
(1.16 MiB) Downloaded 12 times
Chainmail test 1 v3.stl
(2.33 MiB) Downloaded 24 times
Skärmavbild 2018-01-19 kl. 12.59.24.png

User avatar
Noren
Posts: 401
Joined: Sat Nov 26, 2016 12:54 am
Location: Borås, Sweden
Contact:

Re: Bridging is askew and ends in mid air.

Postby Noren » Fri Jan 19, 2018 12:06 pm

It's a file I have created my self. I have double checked and the walls are 2,4 mm thick. And the settings are for a 0,4 mm nozzle and 0,4 extrusion width.

Online
User avatar
Vicky@Raise3D
Posts: 4531
Joined: Fri Mar 25, 2016 3:54 am

Re: Bridging is askew and ends in mid air.

Postby Vicky@Raise3D » Mon Jan 22, 2018 8:55 am

Thanks for your files!
Fixed it already, will release with next version. See the result.
2.png

User avatar
Noren
Posts: 401
Joined: Sat Nov 26, 2016 12:54 am
Location: Borås, Sweden
Contact:

Re: Bridging is askew and ends in mid air.

Postby Noren » Mon Jan 22, 2018 8:57 am

Big thumbs up. I think this have caused me some problems when printing petg. The bridging layer wouldn't stick because some strands in the bridging layer ended and started in mid air.

Online
User avatar
Vicky@Raise3D
Posts: 4531
Joined: Fri Mar 25, 2016 3:54 am

Re: Bridging is askew and ends in mid air.

Postby Vicky@Raise3D » Mon Jan 22, 2018 9:09 am

Thanks for your report and test file shared with us.
If you need, you can advise the printing settings you are currently using, we'd like to slice a file for you to test the result.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 3 guests