Hi,
I noticed two "features" that Raise might consider improving.
after a restart which involved turning off the machine and turning on in another room, the main cooling fan did not turn back on. Print was OK but I'm not sure this is an intended behaviour?
also, I paused to change filament in a 12 hour print. While changing I moved the print head a little bit. Printer restarted printing in completely the wrong position because of that xy offset. I would have thought it could home itself when it enters a pause, and when it leaves a pause...I'll know better next time.
Shane
Issues with restarting a print
- Vicky@Raise3D
- Posts: 4839
- Joined: Fri Mar 25, 2016 3:54 am
Re: Issues with restarting a print
Do you mean the downward fan at right side on single extruder machine or the side nozzle cooling fan?
If the downward fan, can you please move to the Ultilities page to check how much the fan speed is set?
If the side cooling fan, after reboot, does it back to work or not?
For the pause, the head will move to (5,5) after pause code taking effect. And directly move to the print position after resume. There is no homing before printing start.
BTW, you can update the motion board firmware to the latest version on our website. We have added motor-locker after pause.
If the downward fan, can you please move to the Ultilities page to check how much the fan speed is set?
If the side cooling fan, after reboot, does it back to work or not?
For the pause, the head will move to (5,5) after pause code taking effect. And directly move to the print position after resume. There is no homing before printing start.
BTW, you can update the motion board firmware to the latest version on our website. We have added motor-locker after pause.
Who is online
Users browsing this forum: No registered users and 3 guests