Error in Cura printer definition = underextrusion

Discussions about ideaMaker and other printing software.
Posts: 146
Joined: Thu Jun 22, 2017 5:55 am

Error in Cura printer definition = underextrusion

Postby EldRick » Mon Jan 08, 2018 7:33 am

If you use Cura 3.1 with your Raise3D, as I do, you need to know that there is an error in their printer definition for the N2. There is a spurious line of gcode in the printer definition, which sets the first extruder to 94% flow rate (which will be visible in the Tune page on the printer).

To correct this, go to Manage Printers, Activate your Raise3D printer, and delete the following line from the Starting Gcode:

M221 T0 S94

Return to “Software”

Who is online

Users browsing this forum: No registered users and 3 guests