Is it possible to slice 1 body with 2 templates?
In Simplify3D I can set a start and end point for each body so the bottom half prints with 1 template and the top half prints with a different one.
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
No, this is not yet a supported feature in Ideamaker. Same reason for the ask to support for different sized nozzles in the same print. It simply does not yet support complex process features that only a few advanced slicers (s3d is one example) supports today.
Who is online
Users browsing this forum: No registered users and 1 guest