I've been having issues with the print speed.
When I change my Default, Inner Shell, and Outer Shell Speed, my predicted print time isn't adjusting and when I print, everything seems extremely slow. Since my model doesn't have any infill, I haven't been adjusting my infill speed.
Speed: 30mm/s, Estimated print time is 6hrs, 3min, 49sec
Speed: 100mm/s, Estimated print time is 6hrs, 1min, 54sec.
Any advice? Is there a setting I'm missing?
Discussions about ideaMaker and other printing software.
3 posts • Page 1 of 1
Under cooling, minimal layer time. Remember, speed is distance over time. So, another limit here is a layer, regardless of distance defaults to minimum time of 15 seconds. This allows the material to cool and solidify before the next hot layer is applied. You can adjust this lower, but beware of your print deforming as it prints from constantly laying hot layer after hot layer so rapidly, the layers to not solidify in the shape and pull inward.
Who is online
Users browsing this forum: No registered users and 4 guests