Discussions about ideaMaker and other printing software.
8 posts • Page 1 of 1
this bug has been around for a while, I apologize for not mentioning it before. Some generated brim lines cross over each other causing problems on occaision: (this object is what I use for overhang and retraction calibration tests so I slice and print it very often)
any and all are welcome to use this - I print 1 shell 2 bottom and 1 top layer. I cant get fusion of overhang above 45 degrees 200um layers 400 um nozzle, pla in a single layer (i.e top of overhang shows nice bridging but no fusion but 2 layers (bottom of overhang i.e. bottom layer) is passable even up to 75 degrees. The cones are what I use to play with retraction and layer change. For SOME reason the cone edge next to the overhang ramp always has holes at retraction jumping off point. I can't figure out what to even play with here so this is a very quick and difficult test object.
Who is online
Users browsing this forum: No registered users and 2 guests