Touch display not showing real nozzle temperature

Discussions about ideaMaker and other printing software.
Lcis11
Posts: 1
Joined: Sun Jan 13, 2019 3:42 pm

Touch display not showing real nozzle temperature

Postby Lcis11 » Sun Jan 13, 2019 4:31 pm

Need help,

After cleaning jam on left nozzle the touch display is not showing real temperature. I know is working by touching it but display shows 23deg only. The display shows the Right nozzle is the one raising temperature but it’s not hot. It may sound like I switch cables but i did not touch the R nozzle. Display has switch temp.

It will not start a program because it’s not reaching the setup temp (215deg).

User avatar
Vicky@Raise3D
Posts: 4852
Joined: Fri Mar 25, 2016 3:54 am

Re: Touch display not showing real nozzle temperature

Postby Vicky@Raise3D » Tue Jan 15, 2019 2:39 am

Would you like to switch the cables on terminals on extruder board to see whether it shows correctly or not?


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests