After cleaning jam on left nozzle the touch display is not showing real temperature. I know is working by touching it but display shows 23deg only. The display shows the Right nozzle is the one raising temperature but it’s not hot. It may sound like I switch cables but i did not touch the R nozzle. Display has switch temp.
It will not start a program because it’s not reaching the setup temp (215deg).
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Would you like to switch the cables on terminals on extruder board to see whether it shows correctly or not?
Who is online
Users browsing this forum: No registered users and 5 guests