Tip: Send custom GCode while printing

Discussions about ideaMaker and other printing software.
mb300sd
Posts: 71
Joined: Fri Mar 30, 2018 7:22 pm

Tip: Send custom GCode while printing

Postby mb300sd » Thu Dec 20, 2018 1:05 am

Just discovered this was possible, I didn't think it would be since the touchscreen interface takes control of the serial port.

SSH in and type

echo GCODE_HERE > /dev/ttyACM0

It works while a print is active! So you can pause it and command anything you want, or adjust things like the linear advance k factor without even pausing.

Return to “Software”

Who is online

Users browsing this forum: No registered users and 3 guests