I am trying to print a part without infill.
Using IdeaMaker 22.214.171.1243 , The colors of the part seem different that the colors in the legend. I found it difficult to associate the preview of sliced part with the legend next to it.
With infill 0% there was still material deposition between the walls from bottom to top. How could i slice the part with 0% infill above bottom layers and below top layers ?
Any solutions ?
Discussions about ideaMaker and other printing software.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests