Slicing structure colors

Discussions about ideaMaker and other printing software.
RamiRouhana
Posts: 3
Joined: Tue Nov 06, 2018 2:39 pm

Slicing structure colors

Postby RamiRouhana » Tue Nov 06, 2018 2:44 pm

I am trying to print a part without infill.

Using IdeaMaker 3.3.0.2343 , The colors of the part seem different that the colors in the legend. I found it difficult to associate the preview of sliced part with the legend next to it.

With infill 0% there was still material deposition between the walls from bottom to top. How could i slice the part with 0% infill above bottom layers and below top layers ?

Picture attached.

Any solutions ?
Attachments
slicing IdeaMaker.PNG
Colors do not properly match.
With infill 0% the preview still shows infill everywhere.

User avatar
Vicky@Raise3D
Posts: 4418
Joined: Fri Mar 25, 2016 3:54 am

Re: Slicing structure colors

Postby Vicky@Raise3D » Tue Nov 06, 2018 11:23 pm

Would you like to try disable the option of Fill Gaps in Shells under Other tab?

RamiRouhana
Posts: 3
Joined: Tue Nov 06, 2018 2:39 pm

Re: Slicing structure colors

Postby RamiRouhana » Wed Nov 07, 2018 12:00 pm

Thank you very much. That solved it.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 5 guests