Vicky@Raise3D wrote:Cookie wrote:Yes it did thank you, and you guys were quick to sort it out.....
But this morning after a print run my printer is stuck on the green tick screen and none of the 3 buttons work......
So how do I get out of that screen as I have another job ready to do, turning it off had no effect
Please check whether turning off the back power switch helps.
If without power, it still stuck. You need to open the screen cover and unplug the battery.
Just a word of caution. Not related to this firmware update but a few weeks back I unplugged the screen board battery in readiness to fit a reset switch (which I did not do) and on reconnecting the battery plug the screen is now all grey and washed out. Raise say my only option is to buy a new screen or controller board All that was done was disconnect and reconnect the battery while the machine was in a powered down state. So just be cautious.