I have a small problem and would like to see if I am missing an easy way to solve it.
I am printing two models once and would like to be able to use a brim on one and a Skirt on the other.
I think the Group settings would allow this but I don't see an option to control bed adhesion parameters under Group Settings.
Am I missing a way to do this or is the ability not supported yet?
Printer is Pro2, ideaMaker 3.1.7
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests