Cut model in two part and print second part in spiralize is possible using Ideameaker?

Discussions about ideaMaker and other printing software.
sepp974
Posts: 5
Joined: Thu Nov 16, 2017 11:25 am

Cut model in two part and print second part in spiralize is possible using Ideameaker?

Postby sepp974 » Sun Sep 23, 2018 10:57 am

Hello,
I would like know if it is possible using Ideamaker, cut the model in two parts and make a gcode that prints the first part with default parameters but second part must be print in spiralize mode.
Problem is that I have a model (like a vase) with an hole on the base and if I print all in spiralize, slicer "close" the hole.
I have searched in the "group and layer settings" but I have not found anything on the spiralize.
Somebody can help me please?

User avatar
Vicky@Raise3D
Posts: 4305
Joined: Fri Mar 25, 2016 3:54 am

Re: Cut model in two part and print second part in spiralize is possible using Ideameaker?

Postby Vicky@Raise3D » Tue Sep 25, 2018 12:27 am

As Spiral Vase Mode is continuous moving XY and Z directions together for the whole height of the model, not move Z once finish everything at one layer. So you cannot use Vase Mode together with normal layer print at the one print.


Return to “Software”

Who is online

Users browsing this forum: Bing [Bot] and 3 guests