I have an N1 dual extruder. I use the left nozzle for ABS and Edge and want to use the right nozzle for PLA but having set up a profile in IdeaMaker for the right nozzle to print PLA, when I go to slice I get an error message "The temperature of left extruder is low", it seems you can enable right extruder on the Extruder Tab but cannot disable the left extruder.
Any suggestions appreciated.
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests