the lack material code I modified from raises version is controllable via gcode. both turn it off or on and to change the PIN readings. the difference between this version and the marlin 1.1.0 version is that it now uses the endstop gcodes versus a custom gcode. M119 will report status, M120 turns them on. M121 turns them off. Note, I don't have my second one wired in so I know it works with only one.
Marlin has debug command M111 +flags
The flags do different stuff.
S1 echos the parser
S2 prints additional information
S4 prints extra error information
S8 dry run (does not extrude)
S32 is for leveling.
S16, S64, and S128 are reserved for future stuff.
If you run "M111 S1" Marlin will tell you what the raisetouch is sending it.
If you want INFO, ERRORS and PARSER, then M111 S7 will do that.
RL name: Michael Nolen
raise3D N2 kickstarter Early Bird
Trinus Deluxe (running smoothieware on Azteeg X5 GT board)
Monoprice Maker Select v2