printer only prints on lower left corner help!!!

Thoughts about Raise3D, 3D printing and making in general.
davedraven1
Posts: 2
Joined: Sun Jul 08, 2018 3:18 am

printer only prints on lower left corner help!!!

Postby davedraven1 » Sun Jul 08, 2018 3:32 am

"raise3d n2 single"
the photo shows my problem..... trying to print a helmet...........the top and right should be further out and look similar to the left .
manually trying to move the head past the top and right through the lcd does not go past.physically i can move it all around once in a while it will get stuck some what, but i do not think it is a binding issue .but any help will be appreciated...

tried the print in s3d and idea maker same result..
i have printed a cube dead in the middle with no problem...

here is what i have done to this printer since i got it" second hand"...
bondtech upgrade i did the e steps and lowered the voltage to .5 on the first thing in the control box.
switched out the hotend and coupler and heating rod. cause it would not get to temp and stay there.
so everything is good but only prints lower left half of the printer....
Attachments
36776582_10216234307831505_5400306004690731008_n.jpg

davedraven1
Posts: 2
Joined: Sun Jul 08, 2018 3:18 am

Re: printer only prints on lower left corner help!!!

Postby davedraven1 » Wed Jul 11, 2018 4:07 pm

no body has any ideas ? do i need a new motion controller or something?

User avatar
Vicky@Raise3D
Posts: 3778
Joined: Fri Mar 25, 2016 3:54 am

Re: printer only prints on lower left corner help!!!

Postby Vicky@Raise3D » Fri Jul 20, 2018 6:51 am

Manual control for X direction on screen doesn't too? But Y direction works fine?
If so, would you like ask you to try swap the stepper drivers to see the difference.


Return to “General”

Who is online

Users browsing this forum: gamemaker and 8 guests