Hello,
have the problem that all files made with ideamaker Raft & Brim correctly print, but the actual object from about 2.3mm height NO filament is transported.
I also tried different profiles in ideamaker, same problems.
The extruder also clicks
Video: https://youtu.be/PuIh0W1V7MI
As an example, I once attached a bag clip
Pro2+ Problem
Re: Pro2+ Problem
Hello,
Well, I seem to be pursued by bad luck ... or too stupid
After 3 hours of printing, the left extruder no longer conveys filament from height 2.37 / 2.42mm ...
First I thought it might be an ideamaker problem, slicen maybe.
Have made 4 attempts ... with all objects clacking the extruder from 2.37 / 2.42mm and promotes nothing more.
Even with the "Giveaway Spinner (Dual)" without ideamaker, the right extruder works without problems.
Funny it is up to this height everything is running normally.
The pressure (at the extruder) I have already increased several times without improvement.
Small video: https://youtu.be/PuIh0W1V7MI
Extruder left DEFECT? After a day, 3 hours of printing ???
What should I do ?
Well, I seem to be pursued by bad luck ... or too stupid

After 3 hours of printing, the left extruder no longer conveys filament from height 2.37 / 2.42mm ...
First I thought it might be an ideamaker problem, slicen maybe.
Have made 4 attempts ... with all objects clacking the extruder from 2.37 / 2.42mm and promotes nothing more.
Even with the "Giveaway Spinner (Dual)" without ideamaker, the right extruder works without problems.
Funny it is up to this height everything is running normally.
The pressure (at the extruder) I have already increased several times without improvement.
Small video: https://youtu.be/PuIh0W1V7MI
Extruder left DEFECT? After a day, 3 hours of printing ???
What should I do ?
Pro2+ 

Re: Pro2+ Problem
Maybe you chose the wrong material in your prints and the temperature of the Nozzle is to low?
Cheers, David
If you can dream it, you can print it!
If you can dream it, you can print it!

Re: Pro2+ Problem
Maybe ... but i print 3 item with same material, same settings. And fail exact position .... But i will test it.
Pro2+ 

Re: Pro2+ Problem
Please check if you have selected the right material in the Slicer.
Cheers, David
If you can dream it, you can print it!
If you can dream it, you can print it!

Who is online
Users browsing this forum: No registered users and 6 guests