Load/Unload ???

Thoughts about Raise3D, 3D printing and making in general.
User avatar
Korni
Posts: 240
Joined: Wed Apr 11, 2018 8:11 am

Load/Unload ???

Postby Korni » Thu Jul 05, 2018 10:37 pm

Hello,


I think I have a special "problem" (1) ...
When I go to "Unload" on the TouchScreen, my Pro2 + loads the material instead of "ejecting" it

Does anyone know what?
Pro2+ Image

User avatar
Chris@Raise3D
Posts: 8
Joined: Tue Jul 03, 2018 9:42 pm

Re: Load/Unload ???

Postby Chris@Raise3D » Thu Jul 05, 2018 10:58 pm

Hi!
This is called "Pre-load" and is done by design. When you press "unload" the extruder heats up, extrudes a small amount of material, then reverses and unloads the remaining filament. The reason behind this is to make sure the end of the filament does not get caught in the extruder gear as it is unloading.


Return to “General”

Who is online

Users browsing this forum: No registered users and 8 guests