Hello from Belgium

Thoughts about Raise3D, 3D printing and making in general.
Axel
Posts: 8
Joined: Tue May 29, 2018 8:58 am

Hello from Belgium

Postby Axel » Tue May 29, 2018 9:03 am

Hello everyone,

Already possessing 4 printers that I use every day (two Witbox (BQ) and two Zortrax M200) I registered on the forum because I am very interested in the Pro2. I am looking to buy a fifth machine to print the materials that these 4 printers can not print.
I will read what is said on this printer and also ask some questions.

Sorry for my rough English but I am French speaking and use a translator

Axel

Online
Alex M.
Posts: 172
Joined: Tue Apr 10, 2018 4:59 pm

Re: Hello from Belgium

Postby Alex M. » Tue May 29, 2018 8:52 pm

Welcome! There is a lot of good information here on the N1, N2 and N2+ series printer. Currently there is not too much on the Pro2 series since people are just now starting to get them. I'm sure there will be more information as more people begin to use them.

Axel
Posts: 8
Joined: Tue May 29, 2018 8:58 am

Re: Hello from Belgium

Postby Axel » Wed May 30, 2018 6:02 am

Hello Alex M,
Yes, I know that the Pro 2 has just been marketed and that few people have already bought it.
But Raise 3D gives too little information about this model and I hope to have answers here.
I'm going to open a new topic and ask some very specific questions.


Return to “General”

Who is online

Users browsing this forum: No registered users and 9 guests