Thoughts about Raise3D, 3D printing and making in general.
16 posts • Page 1 of 1
And further up in that topic viewtopic.php?f=3&t=362&p=3421&hilit=timezone#p3415
Vicky@Raise3D wrote:Yes, but your firmware version seems a little out of date.
Would you like to update your touchscreen firmware to the latest version and export the log to us again?
Ok I've done it and it seems to be fixed, but after this upgrade when the printer stops printing the build plate lower too much and it's a waste of time. How can I fix this?
Noticed when I STOP a print, it doesn't move the bed bad to 0, but rather some other height quite a distance from 0. Not that it's a huge concern, but it started with the update today...
And could get annoying if pressed for time.
Do you mean that after print stops, the bed just stop at the stopped height but not home to origin height before the next print?
No ma'am. The Bed does not stop at the stopped height, the bed moves down to about the middle of the available Z. Almost as if it were intended to offer our hands more room to remove the model from the bed.
In the current the Z drop after print complete is down to 100mm (if the final height is already over 100mm, the bed will stay at the final height), the previous version was 20mm. The increased height is for providing enough space to remove the model.
We will open this option in future versions for customer to settings how much they want the bed to move in the end.
stevetriple wrote: How can I fix this?
One option is to roll back to 0.9.7, the last firmware update that likely fixes your time stamp issue, but then also does invoke the new bed lowering feature as seen in 0.9.9. Given that 0.9.9 now lets you point at a specific update file and update, I'm not sure if that makes it easier, but something i would consider trying.
Otherwise, the "fix" is to wait for the next update- which I just bugged them about. viewtopic.php?f=3&p=31729#p31729
https://www.raise3d.com/pages/touchscre ... ease-notes
Version 0.9.9 - May 16, 2018
Added a firmware upgrade wizard in Maintenance under Other
Older versions of Raisetouch updates to roll back a version https://www.raise3d.com/pages/raise-touch-all-versions
Who is online
Users browsing this forum: No registered users and 4 guests