I am facing a small problem and I hope that someone might able to give a piece of advice.
I have this printer less than a year. We have done some very succesful prints, but during the last 10 days, the printer after 3 hours of printing will stop extruding. Filament will stop coming out, but the nozzle will keep on moving until the screen says that print was finished successfully.
I have tried to clean the nozzle, change the temperature, change filament or even print with the right extruder but still nothing. I keep on getting the same results. A very smooth print that after 3h more or less remains unfinished. Any ideas?
Thoughts about Raise3D, 3D printing and making in general.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests