Printer failure

[mark_3d]

this morning the i found the printer has stopped ad half print, but this time without screen freezing and i was printing pla with a open enclosure.

[Noren]

My bet is that you need to replace the ribbon cable to the break out board on the extruder. Sounds like the exact random errors I got.

[mark_3d]

My bet is that you need to replace the ribbon cable to the break out board on the extruder. Sounds like the exact random errors I got.

I have Cecked the ribbon cable and it looks OK... It doesn't move...

[Noren]

You have to remove it from the cable harness to be able to inspect it. Or measure each strand from end to end with a multimeter. It breaks inside the plastic cable harness from the hotend. If you hasn’t done it already. Open a ticket with support at help.raise3d.com

[DetroitCW]

Same failure here. After just 1 print.


Looking for a solution that is a bit more versatile. I would hate to have to replace this cable after every few prints.

[Noren]

Same failure here. After just 1 print.


Looking for a solution that is a bit more versatile. I would hate to have to replace this cable after every few prints.

Someone mentioned replacing them with a braided cable. But I don’t have any info about what kind of cable and connector. If someone has info about this, please share.

Also if anyone has info about what type av cable chain that would fit the N1 I would be happy. And how to attach the cable chain to the printer.

[jack26]

Hello,

I saw your error pic that type of error generated when you run printer in hot temperature & machine does not perform.so just stop for few minutes after that again run. Do that step.
Thanks...