Raft Problems

Thoughts about Raise3D, 3D printing and making in general.
Posts: 1
Joined: Wed Dec 06, 2017 6:55 am

Raft Problems

Postby WepfAir » Tue Jan 09, 2018 11:30 am

Raft problems
When printing a file there is always the same error during rafting.
The last layer of the raft is warped identically. (see. Picture)

I think if the fault is caused by one of the timing belts or what could be the reason?

I use a Raise3D N2 Plus


User avatar
Posts: 2775
Joined: Fri Mar 25, 2016 3:54 am

Re: Raft Problems

Postby Vicky@Raise3D » Wed Jan 10, 2018 6:16 am

Please help try a test print with lower Surface Layer Infill Raftio.

The default value should be 85%, try 75% and share the result with us.

Posts: 2
Joined: Wed Jan 10, 2018 11:55 pm

Re: Raft Problems

Postby Levi3D » Thu Jan 11, 2018 12:54 am

Hey WepfAir,

Its unlikely a mechanical error because its missing some layers on the exact same spot.
Click the Preview icon and check the bottom of the model by adjusting the Layer scroll bar and see if will show the missing layers.
If its missing then check your stl file if there are holes at the bottom surface, you can also click the Repair if that will remedy the issue.

Return to “General”

Who is online

Users browsing this forum: No registered users and 3 guests