163 days of print time on N2

[checktest]

Dashboard is up to 100 days of print time! That machine really has an additional 1500 hours on it before the Dashboard and print time tracking feature were implemented. So actual total is closer to 163 days print time. Also another 18 days on my newer N2 Plus.

There's probably a lot of you that have me beat, but I just thought it was cool and so figured I'd share. It's not been without some issues and tinkering, but it has still been quite a workhorse.

[Michael.P@Raise3D]

Welcome to the 100 day club, it is good to have another member among our ranks!

[Allan Sche Sar]

How can I activate the Dashboard? My dashboard say after 7 month zero g

[Vicky@Raise3D]

Which version of touchscreen firmware are you using? Did you wait until the Done button jump out after printing complete? When the completely finished print task will be recorded in dashboard.

[Allan Sche Sar]

Since 1 h I use the firmware version 1.1.6 and 0.9.2. Befor I used 1.1.1 and 0.7.2.
Yes I wait and press done.
I make a new test again (results in 0:45 hours). The setting "Collect Print Statistic" is active.

[Allan Sche Sar]

Okay it runs.

@checktest nice statistic