I know that some N2 was changed to Bondtech extruders.
Is there someone who use S3D and has done a dualprint?
My printer works fine with the Bondtech extruders and I can make a dualprint if I use Ideamaker.
But I prefer S3D maybe I have some experiance with S3D and no experiance with Ideamaker.
But my printer didnt run with programms created with S3D.
Before I change to Bondtech it works.
If somebody use S3D, Raise N2+ and Bondtech I have some questions for the starting script.
Thoughts about Raise3D, 3D printing and making in general.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests