Thoughts about Raise3D, 3D printing and making in general.
8 posts • Page 1 of 1
zemlin wrote:IMHO, weight isn't the real issue, but stability while the printer is in operation. A table rated for well over the machine weight might still wiggle like jello when printing.
I think the same. It all makes for resonance, right? I made a shelf in the corner of my office from some leftover kitchen worktop - it's 40mm thick solid Beech, so nice and heavy. That's fastened down to batons on two brick walls, with the furthest corner supported by a leg down to the floor. I made the shelf 860mm from floor level, which for me (5'10" ish) is a nice height when setting up, checking or removing prints. I also added a small piece of the dense packing foam the machine came in near the top, which made a surprising difference in damping down movement.
Who is online
Users browsing this forum: No registered users and 3 guests