Problem with heating hot end

Thoughts about Raise3D, 3D printing and making in general.
Caroulus
Posts: 1
Joined: Sun Feb 19, 2017 1:42 pm

Problem with heating hot end

Postby Caroulus » Sun Feb 19, 2017 2:02 pm

Hello,
i have a new n1 with the dual V2 hotend.
Now I have a problem with heating up the Hotend, whenever I try to print a Object and the Printer tries to heat up the nozzle it stops ten degrees below the needed heat to print the Filament. This Problem happens on both Extruders but not the Heat plate.

User avatar
walshlg
Posts: 1098
Joined: Wed Mar 23, 2016 12:01 pm

Re: Problem with heating hot end

Postby walshlg » Mon Feb 20, 2017 2:17 am

check the controller screens, set the warmup temperature with the far left tab, this window gives you real time feedback. Then go to utilities to load the filament, it won't load until within a degree of the loading temperature, then select print and it wont print until it warms up/ cools down to the temps set in the print gcode

User avatar
Vicky@Raise3D
Posts: 1854
Joined: Fri Mar 25, 2016 3:54 am

Re: Problem with heating hot end

Postby Vicky@Raise3D » Sat Feb 25, 2017 5:03 pm

How much offset is between the final heating stop temperature with the target temperature?
Seems have something wrong with the hardware.


Return to “General”

Who is online

Users browsing this forum: Monty, socke and 3 guests