i installed on my 2 raise N2 and N2+ the Filament Run-out Sensor since 2 days
upgraded the firmware of the Motion Controller Board with N2PLUS-Dual-1.1.6frs and the other but for the N2
upgraded RaiseTouch with the last version (updater_1_0_0_831.raisepack)
and i have the same issue on the two printers with differente files and differents settings
Error:No Line Number with checksum....
what the problems?usb transfert on 2 printers ?????????????
Thoughts about Raise3D, 3D printing and making in general.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: Deepspaceobject and 7 guests