Buildplate Glass Brake

Thoughts about Raise3D, 3D printing and making in general.
Posts: 72
Joined: Tue Feb 20, 2018 3:50 pm

Buildplate Glass Brake

Postby mark_3d » Thu Aug 02, 2018 11:15 am

It's happen to me that after a big print was finished the blass was curved and when i tried to remove the printed part, the glass brake. I usually use dimafix and was printing abs x. It could be tension between the printed part and the glass?

Return to “General”

Who is online

Users browsing this forum: No registered users and 2 guests