Bashing into Parts

Thoughts about Raise3D, 3D printing and making in general.
Posts: 2
Joined: Mon Jul 30, 2018 7:48 pm

Bashing into Parts

Postby Tony » Mon Jul 30, 2018 7:52 pm

My brand new Raise3D Pro2 plus keeps banging into parts causing them to rip off supports and miss-aligning the printing head. So whatever it then prints is a disaster.
Am I not using enough supports?
Tighter spacing?
Any help or comments most appreciated. Thanks!

User avatar
Posts: 4816
Joined: Fri Mar 25, 2016 3:54 am

Re: Bashing into Parts

Postby Vicky@Raise3D » Wed Aug 01, 2018 12:05 am

Have you double confirm the nozzle distance to bed surface with the feeler gauge based on the steps in Quick Starter Guide?
And whether the nozzle jogging works properly on your printer?

Posts: 38
Joined: Mon Mar 19, 2018 8:27 pm

Re: Bashing into Parts

Postby maxamillo » Wed Aug 01, 2018 1:47 pm

Add zhop

Posts: 368
Joined: Thu Jul 12, 2018 8:34 pm

Re: Bashing into Parts

Postby Shelton » Wed Aug 01, 2018 6:45 pm

Or check few reverence points on the bed - distortion?

Return to “General”

Who is online

Users browsing this forum: No registered users and 5 guests