Page 1 of 1

Printer Settings

Posted: Wed Sep 26, 2018 2:21 am
by Brad
Hi Guys,

I upgraded my early n2 plus to the bondtech extruders which have 140 steps per mm. I had to modify and create a new printer in ideamaker to do this. Can I do something similar in raise cloud?
The other benefit of using ideamaker was that when i changed to a different printer setting that had a different nozzle, it automatically populated the slicing profiles with the ones for that nozzle, can this happen as well?

Thanks,

Brad

Re: Printer Settings

Posted: Wed Sep 26, 2018 5:27 pm
by Vicky@Raise3D
You can change extrusion width in slicing settings for different nozzle sizes.
RaiseCould does not have any setting related to Step-E by now. We will add this need into developing list. Thanks for your feedback.
We currently more recommend to slice file in ideaMaker and upload gcode file to RaiseCloud if you need some advanced settings. And use remote control and monitor in RaiseCloud. We will keep on improving slicing section on RaiseCloud.