The power switch for the Pro2 machine is at the rear bottom corner. I have my machine mounted on a 4-wheel dolly, and rolled under my desk. This means that for everytime I need to turn it on/off, I have to roll it out and reach down almost to the floor. My old back and knees hate it...
I've been getting around this by plugging the machine into a power strip that is on the desk, then just flicking the switch on the power strip. So from the printer's perspective, it's seeing a power outage everytime I'm done using it.
Is this ok? Is there any damage to the hardware by doign a hardpower cut instead of flicking the machine power switch? Not sure if the system goes through any short 'shut down' procedure before actually powering down properly.
Any info appreciated. Thanks.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest