my plate is bad leveled.
The problem is that the middle part of the table is higher then sides ( the midline parallel to Y axis is higher). I tried to level the plate. However, the nylon screw are even not touching the plate so by rotating them I can lower the bed! One would say try to raise sides instead. Yes, I could do it, but my plate is in the lowest possible position according to Z axis. I can't lower the bed as well! So I stuck.
I tried to raise the nozzle. I did it a little bit, but still it is not enough. I don't know if there is any other method to raise the nozzle more?
Any other ideas?
4 posts • Page 1 of 1
Try to adjust corners first... use digital gauge for it. It will be easier.
do you have stl for digital gauge holder?
You can find it here on the forum and on https://www.thingiverse.com also.
Who is online
Users browsing this forum: RiserDog and 1 guest