3 posts • Page 1 of 1
I'm hoping that someone can give me clear directions on how to connect the two sets of wires from a BLTouch to the control board on my N2. I've looked at the instructions at vilify.se, and at viewtopic.php?f=4&t=1030. I think I understand the Brown/Red/Orange connection to the +5v pair and the pin on EXP3. What I'm not sure of is do I disconnect the existing White/Black pair on Z- and substitute the BLTouch pair instead, leaving the old connector unused?
Who is online
Users browsing this forum: No registered users and 2 guests