Noise ....

User avatar
Korni
Posts: 219
Joined: Wed Apr 11, 2018 8:11 am

Noise ....

Postby Korni » Tue Sep 25, 2018 10:17 am

Where / Why is this noise ???
Y-Drive
The first 1-2 seconds

https://youtu.be/C0jg0URvCbU
Pro2+ Image

Shelton
Posts: 226
Joined: Thu Jul 12, 2018 8:34 pm

Re: Noise ....

Postby Shelton » Tue Sep 25, 2018 1:29 pm

Nozzle grind on material probably

User avatar
Korni
Posts: 219
Joined: Wed Apr 11, 2018 8:11 am

Re: Noise ....

Postby Korni » Tue Sep 25, 2018 1:53 pm

Shelton wrote:Nozzle grind on material probably



I hope it ;-)
Pro2+ Image

simon_srp
Posts: 7
Joined: Fri Aug 31, 2018 10:18 am

Re: Noise ....

Postby simon_srp » Fri Sep 28, 2018 11:20 am

I had the same issue in one of my printing tasks.. Probably because I changed the layer thickness a bit? I dont think it's because my piece were warped because when it was finished the measurements were fine.

Shelton
Posts: 226
Joined: Thu Jul 12, 2018 8:34 pm

Re: Noise ....

Postby Shelton » Fri Sep 28, 2018 5:26 pm

If this is PLA try to adjust Z-hop value 0.2 to 0.5 mm. Lower temp, nozzle flow and filament feed.


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 1 guest