Raise3D Pro2 Clicking, Stops Extruding, Cold-Side Clogs

mastersapo
Posts: 6
Joined: Sat May 26, 2018 3:13 am

Re: Raise3D Pro2 Clicking, Stops Extruding, Cold-Side Clogs

Postby mastersapo » Sun Nov 04, 2018 2:20 am

I just started getting this issue too on my right extruder on my Pro2 Plus. Everything was fine except the occasional layer shift during a long (12+ hour) print. Then over the last 3 days it started getting clogged mid print. I would unload, clear, reload, re-print and it would re-clog. The jam appears to be below the extruder based on the steel string bottoming out.

Once I take the extruder apart, i'll post pictures of what I find, but in the meantime I have a help ticket submitted.


Return to “Pro2 Series”

Who is online

Users browsing this forum: No registered users and 2 guests