N1 Table Resonance

Flightrider
Posts: 20
Joined: Sat Jun 25, 2016 9:21 pm

N1 Table Resonance

Postby Flightrider » Sun Jan 20, 2019 6:06 pm

Wondering if anyone else has any problems with the N1 table flexibility when printing taller models. I love this printer, but I'm learning to print towards the back of the table as much as possible, especially on taller models.

The attached shows a allen wrench holder I attempted to print, laid our front to back and it spanned almost the entire table. I left for a while and came back to see the table resonating. Long table, cantilever design. Doesn't take much of a bump to make this happen.

Dave
Attachments
IMG_7827.JPG

Jetguy
Posts: 2706
Joined: Tue Mar 22, 2016 1:40 am
Location: In a van, down by the river

Re: N1 Table Resonance

Postby Jetguy » Tue Jan 22, 2019 4:15 pm


Flightrider
Posts: 20
Joined: Sat Jun 25, 2016 9:21 pm

Re: N1 Table Resonance

Postby Flightrider » Wed Jan 23, 2019 4:40 am

Thanks JG, I'm going to strengthen that corner in the same manner you did. Great write up.

Regards,

Dave


Return to “N Series”

Who is online

Users browsing this forum: No registered users and 1 guest